JSP Ridgeback® Speed Bump Kit 50mm

The JSP Ridgeback Speed Bump Kit 50mm can be installed quickly and easily onto site and assists with slowing traffic to approximately 10km/h. Each speed bump kit is made from highly durable rubber sections and when you order the kit you get all mid-sections, end caps and fixings you need to complete the ramp.

Each ramp is 50mm high which is perfect for slowing standard traffic down appropriately and helps to keep motorists from speeding. Each section comes with thermoplastic retro-reflective markings which make the ramps highly visible to motorists when they are in place, perfect for roadways, underground car parks and more.

The Ridgeback® speed bumps also include an integral cable ramp that can house hoses or cables on-site. Simply insert the cable underneath during installation and they will be protected, even when cars are moving over the speed ramp.

Installing the Ridgeback Speed Bump Kit 50mm

To install the Ridgeback simply mark the area for each section and drill into position. Insert the fixings into place and tighten into place as necessary. Be sure not to overtighten the fixings during installation.

The speed bump sections and end caps can be easily joined together using the integral joining system. This allows the sections to be connected quickly when installing the bump and helps to keep the sections together. This system allows the speed bump to remain in place for long-term use.